Promo banner

Change Car Particulate Filter (DPF) Land Rover Range Rover Evoque

Change Car Particulate Filter (DPF)

Easy 0h30–8h00 ~50–800£
Estimated time 0h30–8h00
Estimated labour cost ~50–800£
Difficulty Easy
Vehicles
Range Rover Evoque 2010-2018 4
  • 2.0 TD4 Diesel (204DTA)
  • 2.0 TD4 Diesel (204DTD)
  • SD4 (2.2D) Diesel (224DT)
  • TD4 (2.2D) Diesel (224DT)
Range Rover Evoque 2019-2025 7
  • D150 (2.0 MHEV) 48V (MHEV),Diesel (204DTD)
  • D150 (2.0) Diesel (204DTD)
  • D165 (2.0 MHEV) 48V (MHEV),Diesel (204DTY)
  • D165 (2.0) Diesel (204DTY)
  • D180 (2.0 MHEV) 48V (MHEV),Diesel (204DTD)
  • D200 (2.0 MHEV) 48V (MHEV),Diesel (204DTY)
  • D240 (2.0 MHEV) 48V (MHEV),Diesel (204DTA)
Remove/refit the catalytic converter 2h00–6h00
Renew the catalytic converter 2h00–6h00
Remove/refit the diesel particulate filter 1h30–8h00
Renew the diesel particulate filter 1h30–8h00
Prepare the catalytic converter heat shield for installation* 0h45
Remove/refit the AdBlue heater 0h45
Renew the AdBlue pump 1h30
Renew the AdBlue heater 0h45
Check/top up the diesel particulate filter fuel additive 1h00
Renew the diesel particulate filter fuel additive reservoir 0h45–1h30
Remove/refit the diesel particulate filter fuel additive reservoir 0h45–1h30
Remove/refit the diesel particulate filter fuel additive injector 0h45
Renew the diesel particulate filter fuel additive injector 0h45
Remove/refit the AdBlue tank 0h45–3h00
Drain/refill the AdBlue tank 0h45–1h00
Renew the AdBlue tank 0h45–3h00
Remove/refit the AdBlue injector 0h45
Renew the AdBlue injector 0h45
Check the catalytic converter 0h30
Remove/refit the diesel particulate filter/catalytic converter assembly 2h00
Renew the diesel particulate filter/catalytic converter assembly 2h00
Carry out the diesel particulate filter regeneration procedure 0h45
Remove/refit the diesel particulate filter With selective catalytic reduction (SCR) system 8h00
Remove/refit the diesel particulate filter Without selective catalytic reduction (SCR) system 6h00
Renew the diesel particulate filter With selective catalytic reduction (SCR) system 8h00
Renew the diesel particulate filter Without selective catalytic reduction (SCR) system 6h00
Remove/refit the AdBlue injector Secondary component 1h00
Remove/refit the AdBlue injector Main component 3h00
Renew the AdBlue injector Secondary component 1h00
Renew the AdBlue injector Main component 3h00

What is a Land Rover Range Rover Evoque particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Land Rover Range Rover Evoque particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Land Rover Range Rover Evoque particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Land Rover Range Rover Evoque particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Land Rover Range Rover Evoque particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.

2 models covered

Model Year Range Engines covered Fuel
Range Rover Evoque 2010-2018 2010-2018 2.0 GTDi (Si4) Petrol (204PT), 2.0 I4 Petrol (PT204), 2.0 Petrol (PT204), 2.0 TD4 Diesel (204DTA), 2.0 TD4 Diesel (204DTD), SD4 (2.2D) Diesel (224DT), TD4 (2.2D) Diesel (224DT) Diesel, Petrol
Range Rover Evoque 2019-2025 2019-2025 D150 (2.0 MHEV) 48V (MHEV),Diesel (204DTD), D150 (2.0) Diesel (204DTD), D165 (2.0 MHEV) 48V (MHEV),Diesel (204DTY), D165 (2.0) Diesel (204DTY), D180 (2.0 MHEV) 48V (MHEV),Diesel (204DTD), D200 (2.0 MHEV) 48V (MHEV),Diesel (204DTY), D240 (2.0 MHEV) 48V (MHEV),Diesel (204DTA), P20… 48V (MHEV), Diesel, Electricity, Petrol