Promo banner

Change Car Particulate Filter (DPF) Hyundai Elantra

Change Car Particulate Filter (DPF)

Easy 0h30–2h00 ~50–200£
Estimated time 0h30–2h00
Estimated labour cost ~50–200£
Difficulty Easy
Vehicles
Elantra III 2000-2014 1
  • 2.0 CRDi Diesel (D4EA)
Elantra IV 2005-2011 1
  • 1.6 CRDi Diesel (D4FB)
Elantra VI 2016-2025 1
  • 1.6 CRDi Diesel (D4FB)
Check the catalytic converter 0h30
Remove/refit the catalytic converter 1h30–2h00
Renew the catalytic converter 1h30–2h00
Remove/refit the diesel particulate filter 0h45
Renew the diesel particulate filter 0h45
Prepare the catalytic converter heat shield for installation* 0h45

What is a Hyundai Elantra particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Hyundai Elantra particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Hyundai Elantra particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Hyundai Elantra particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Hyundai Elantra particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.

5 models covered

Model Year Range Engines covered Fuel
Elantra I 1991-1995 1991-1995 1.6 Petrol (G4CR), 1.8 Petrol (G4CN) Petrol
Elantra III 2000-2014 2000-2014 1.6 Petrol (G4ED), 1.6 Petrol (G4ED), 1.6 Petrol (G4GR), 1.8 Petrol (G4GB), 2.0 16V Petrol (G4GC), 2.0 16V Petrol (G4GC-V), 2.0 CRDi Diesel (D4EA) Diesel, Petrol
Elantra IV 2005-2011 2005-2011 1.6 CRDi Diesel (D4FB) Diesel
Elantra V 2009-2016 2009-2016 1.6 MPi Petrol (G4FG), 1.8 MPi Petrol (G4NB) Petrol
Elantra VI 2016-2025 2016-2025 1.6 CRDi Diesel (D4FB), 1.6 MPi Petrol (G4FG), 1.6 T-GDi Petrol (G4FJ), 2.0 MPi Petrol (G4NA) Diesel, Petrol