Change Car Particulate Filter (DPF) Audi Q3
Change Car Particulate Filter (DPF)
| Estimated time | 0h30–1h30 |
|---|---|
| Estimated labour cost | ~50–150£ |
| Difficulty | Easy |
| Vehicles |
Q3 2012-2018 13
Q3 2018-2025 5
|
| Check the catalytic converter | 0h30 |
| Check/top up the diesel particulate filter fuel additive | 0h30 |
| Check the diesel particulate filter saturation (using a diagnostic tool) | 0h30 |
| Renew the diesel particulate filter fuel additive reservoir | 1h30 |
| Remove/refit the diesel particulate filter fuel additive reservoir | 1h30 |
| Remove/refit the catalytic converter | 1h30–8h00 |
| Renew the catalytic converter | 1h30–8h00 |
| Renew the catalytic converter gasket | 1h30–8h00 |
| Remove/refit the diesel particulate filter | 3h30–14h00 |
| Remove/refit the diesel particulate filter fuel additive injector | 1h30 |
| Remove/refit the petrol particulate filter | 12h00–14h00 |
| Renew the petrol particulate filter | 12h00–14h00 |
| Renew the diesel particulate filter | 4h00–14h00 |
| Renew the diesel particulate filter fuel additive injector | 1h30 |
| Remove/refit the diesel particulate filter/catalytic converter assembly | 3h30 |
| Renew the diesel particulate filter/catalytic converter assembly | 3h30 |
| Remove/refit the petrol particulate filter temperature sensor | 0h30–0h45 |
| Remove/refit the petrol particulate filter differential pressure sensor | 0h30–0h45 |
| Renew the petrol particulate filter differential pressure sensor | 0h30–0h45 |
| Renew the petrol particulate filter temperature sensor | 0h30–0h45 |
| Prepare the catalytic converter heat shield for installation* | 0h45 |
| Remove/refit the AdBlue tank control unit | 0h45–1h30 |
| Remove/refit the AdBlue tank | 1h30–3h30 |
| Renew the AdBlue tank control unit | 0h45–1h30 |
| Renew the AdBlue tank | 2h00–3h30 |
| Remove/refit the diesel particulate filter 4WD | 12h00 |
| Renew the diesel particulate filter 4WD | 13h00 |
| Remove/refit the diesel particulate filter Front-wheel drive | 11h00 |
| Remove/refit the diesel particulate filter fuel additive injector N758 | 1h00 |
| Remove/refit the diesel particulate filter fuel additive injector N474 | 0h45 |
| Renew the diesel particulate filter Front-wheel drive | 11h00 |
| Renew the diesel particulate filter fuel additive injector N474 | 0h45 |
| Renew the diesel particulate filter fuel additive injector N758 | 1h00 |
| Drain/refill the AdBlue tank | 1h00 |
What is a Audi Q3 particulate filter?
Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.
How does the Audi Q3 particulate filter work?
As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.
When should you change the Audi Q3 particulate filter?
The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.
Can the Audi Q3 particulate filter be cleaned instead of replaced?
Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.
Is it difficult to change the Audi Q3 particulate filter?
Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.
2 models covered
| Model | Year Range | Engines covered | Fuel |
|---|---|---|---|
| Q3 2012-2018 | 2012-2018 | 1.4 TFSI Petrol (CHPB), 1.4 TFSI Petrol (CZDA), 1.4 TFSI Petrol (CZDB), 1.4 TFSI Petrol (CZEA), 2.0 TDI Diesel (CFFA), 2.0 TDI Diesel (CFFB), 2.0 TDI Diesel (CFGB), 2.0 TDI Diesel (CFGC), 2.0 TDI Diesel (CFGD), 2.0 TDI Diesel (CUVB), 2.0 TDI Diesel (CUVC), 2.0 TDI Diesel (CUVD),… | Diesel, Petrol |
| Q3 2018-2025 | 2018-2025 | 35 TDI Diesel (DFGA), 35 TDI Diesel (DTSA), 35 TDI Diesel (DTSB), 35 TFSI Petrol (DADA), 35 TFSI Petrol (DFYA), 35 TFSI Petrol (DPCA), 35 TFSI Petrol (DXDB), 40 TDI Diesel (DFHA), 40 TDI Diesel (DTUA), 40 TFSI Petrol (DKTC), 40 TFSI Petrol (DNNA), 45 TFSI e Electricity,Petrol (D… | Diesel, Electricity, Petrol |
