Promo banner

Change Car Accessory Belt Kit Volkswagen Crafter

Change Car Accessory Belt Kit

Easy 0h30–2h30 ~50–250£
Estimated time 0h30–2h30
Estimated labour cost ~50–250£
Difficulty Easy
Renew the ancillary drive belt 0h30–2h30
Renew the engine oil and filter Front-wheel drive 1h30
Renew the engine oil and filter 4WD 1h30–2h00
Renew the engine oil and filter 1h30

What is a Volkswagen Crafter accessory belt?

The accessory belt (also called the auxiliary belt or serpentine belt) allows the engine to drive peripheral components such as the alternator, air conditioning compressor, power steering pump, and sometimes the water pump.

When should you change the Volkswagen Crafter accessory belt?

Typical replacement is every 60,000–120,000 km or 4–6 years. Signs of wear include: squealing noise (especially at start-up or in wet weather), visible cracks or fraying. Always replace the tensioner and any idler pulleys at the same time.

Is it difficult to change the Volkswagen Crafter accessory belt?

Difficulty level 2/5: technically easy. Key steps: note the belt routing before removal, release the automatic tensioner, slide off the old belt, replace tensioner and idler pulleys, route the new belt, release the tensioner to apply tension.

2 models covered

Model Year Range Engines covered Fuel
Crafter 2006-2016 2006-2016 CR28 2.0 TDI Diesel (CKTB), CR28 2.0 TDI Diesel (CKTC), CR28 2.0 TDI Diesel (CKUB), CR28 2.0 TDI Diesel (CSNA), CR28 2.5 TDI Diesel (BJJ), CR28 2.5 TDI Diesel (BJK), CR28 2.5 TDI Diesel (BJL), CR28 2.5 TDI Diesel (BJM), CR28 2.5 TDI Diesel (CEBA), CR28 2.5 TDI Diesel (CEBB), CR2… Diesel
Crafter 2017-2025 2017-2025 CR30 2.0 TDI Bi-Turbo Diesel (DAVA), CR30 2.0 TDI Bi-Turbo Diesel (DMZB), CR30 2.0 TDI Diesel (DAUA), CR30 2.0 TDI Diesel (DAUB), CR30 2.0 TDI Diesel (DNAD), CR30 2.0 TDI Diesel (DNAE), CR35 2.0 TDI Bi-Turbo Diesel (DAVA), CR35 2.0 TDI Bi-Turbo Diesel (DAWA), CR35 2.0 TDI Bi-Tur… Diesel