Promo banner

Change Car Accessory Belt Kit

Easy 0h30–0h45 ~50–75£
Estimated time 0h30–0h45
Estimated labour cost ~50–75£
Difficulty Easy
Vehicles
626 1987-1992 2
  • 2.0 8V Petrol (FE)
  • 2.2i 12V Petrol (F2)
626 1992-1997 2
  • 2.0i 16V Petrol (FS)
  • 2.5i V6 24V Xerxes Petrol (KL)
626 1997-2003 1
  • 2.0 HP Petrol (FS)
Renew the air-conditioning compressor drive belt 0h30–0h45
Renew the ancillary drive belt 0h30–1h00
Renew the engine oil and filter 1h00

What is a Mazda 626 accessory belt?

The accessory belt (also called the auxiliary belt or serpentine belt) allows the engine to drive peripheral components such as the alternator, air conditioning compressor, power steering pump, and sometimes the water pump.

When should you change the Mazda 626 accessory belt?

Typical replacement is every 60,000–120,000 km or 4–6 years. Signs of wear include: squealing noise (especially at start-up or in wet weather), visible cracks or fraying. Always replace the tensioner and any idler pulleys at the same time.

Is it difficult to change the Mazda 626 accessory belt?

Difficulty level 2/5: technically easy. Key steps: note the belt routing before removal, release the automatic tensioner, slide off the old belt, replace tensioner and idler pulleys, route the new belt, release the tensioner to apply tension.

4 models covered

Model Year Range Engines covered Fuel
626 1983-1987 1983-1987 2.0 8V Petrol (FE), 2.0i 8V GT Petrol (FE) Petrol
626 1987-1992 1987-1992 1.8 12V Petrol (F8), 2.0 8V Petrol (FE), 2.2i 12V Petrol (F2) Petrol
626 1992-1997 1992-1997 2.0i 16V Petrol (FS), 2.5i V6 24V Xerxes Petrol (KL) Petrol
626 1997-2003 1997-2003 2.0 HP Petrol (FS) Petrol