Promo banner

Change Car Particulate Filter (DPF) Citroen Jumper III

Change Car Particulate Filter (DPF)

Easy 0h30–3h30 ~50–350£
Estimated time 0h30–3h30
Estimated labour cost ~50–350£
Difficulty Easy
Vehicles
Jumper III 2006-2025 21
  • 2.0 BlueHDi Diesel (DW10FUC (AHP))
  • 2.0 BlueHDi Diesel (DW10FUD (AHN))
  • 2.0 BlueHDi Diesel (DW10FUE (AHM))
  • 2.2 BlueHDi 120 Diesel (DW12RUE (4HA))
  • 2.2 BlueHDi 120 Diesel (DW12RUE (4HK))
  • 2.2 BlueHDi 140 Diesel (DW12RUD (4HB))
  • 2.2 BlueHDi 140 Diesel (DW12RUD (4HJ))
  • 2.2 BlueHDi 165 Diesel (DW12RUC (4HC))
  • 2.2 BlueHDi 165 Diesel (DW12RUC (4HH))
  • 2.2 HDi Diesel (P22DTE (4HU))
  • 2.2 HDi Diesel (P22DTE (4HV))
  • 2.2 HDi Diesel (P22DTE+ (4HM))
  • 2.2 HDi FAP Diesel (PUMA-C (4HG))
  • 2.2 HDi FAP Diesel (PUMA-C (4HH))
  • 2.2 HDi FAP Diesel (PUMA-C (4HJ))
  • 3.0 HDi Diesel (F1CE3481DM)
  • 3.0 HDi FAP Diesel (F1CE0481D)
  • 3.0 HDi FAP Diesel (F1CE0481E)
  • 3.0 HDi FAP Diesel (F1CE0481E)
  • 3.0 HDi FAP Diesel (F1CE3481E)
  • 3.0 HDi FAP Diesel (F1CE3481N)
Remove/refit the diesel particulate filter/catalytic converter assembly 1h30–2h00
Renew the diesel particulate filter/catalytic converter assembly 1h30–2h00
Prepare the catalytic converter heat shield for installation* 0h45
Renew the diesel particulate filter fuel additive reservoir 1h30
Remove/refit the diesel particulate filter fuel additive reservoir 1h30
Remove/refit the AdBlue tank 1h30–2h00
Renew the AdBlue tank 1h30–2h00
Remove/refit the catalytic converter 2h00–3h30
Renew the catalytic converter 2h00–3h30
Remove/refit the diesel particulate filter 1h30–2h00
Remove/refit the diesel particulate filter fuel additive injector 0h45
Renew the diesel particulate filter 1h30–2h00
Renew the diesel particulate filter fuel additive injector 0h45
Drain/refill the AdBlue tank 0h45
Check the catalytic converter 0h30
Remove/refit the pre-catalytic converter 2h00
Renew the pre-catalytic converter 2h00
Prepare the catalytic converter heat shield for installation 0h30

What is a Citroen Jumper III particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Citroen Jumper III particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Citroen Jumper III particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Citroen Jumper III particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Citroen Jumper III particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.