Promo banner

Change Car Accessory Belt Kit Citroen Jumper III

Change Car Accessory Belt Kit

Easy 0h30–3h00 ~50–300£
Estimated time 0h30–3h00
Estimated labour cost ~50–300£
Difficulty Easy
Vehicles
Jumper III 2006-2025 21
  • 2.0 BlueHDi Diesel (DW10FUC (AHP))
  • 2.0 BlueHDi Diesel (DW10FUD (AHN))
  • 2.0 BlueHDi Diesel (DW10FUE (AHM))
  • 2.2 BlueHDi 120 Diesel (DW12RUE (4HA))
  • 2.2 BlueHDi 120 Diesel (DW12RUE (4HK))
  • 2.2 BlueHDi 140 Diesel (DW12RUD (4HB))
  • 2.2 BlueHDi 140 Diesel (DW12RUD (4HJ))
  • 2.2 BlueHDi 165 Diesel (DW12RUC (4HC))
  • 2.2 BlueHDi 165 Diesel (DW12RUC (4HH))
  • 2.2 HDi Diesel (P22DTE (4HU))
  • 2.2 HDi Diesel (P22DTE (4HV))
  • 2.2 HDi Diesel (P22DTE+ (4HM))
  • 2.2 HDi FAP Diesel (PUMA-C (4HG))
  • 2.2 HDi FAP Diesel (PUMA-C (4HH))
  • 2.2 HDi FAP Diesel (PUMA-C (4HJ))
  • 3.0 HDi FAP Diesel (F1CE0481D)
  • 3.0 HDi FAP Diesel (F1CE0481E)
  • 3.0 HDi FAP Diesel (F1CE0481E)
  • 3.0 HDi FAP Diesel (F1CE3481E)
  • 3.0 HDi FAP Diesel (F1CE3481N)
  • ë-Jumper Electricity (ZA7)
Renew the ancillary drive belt 1h30–3h00
Renew the engine oil and filter 0h45–1h30
Renew the air-conditioning compressor drive belt 0h30–3h00

What is a Citroen Jumper III accessory belt?

The accessory belt (also called the auxiliary belt or serpentine belt) allows the engine to drive peripheral components such as the alternator, air conditioning compressor, power steering pump, and sometimes the water pump.

When should you change the Citroen Jumper III accessory belt?

Typical replacement is every 60,000–120,000 km or 4–6 years. Signs of wear include: squealing noise (especially at start-up or in wet weather), visible cracks or fraying. Always replace the tensioner and any idler pulleys at the same time.

Is it difficult to change the Citroen Jumper III accessory belt?

Difficulty level 2/5: technically easy. Key steps: note the belt routing before removal, release the automatic tensioner, slide off the old belt, replace tensioner and idler pulleys, route the new belt, release the tensioner to apply tension.