Promo banner

Change Car Particulate Filter (DPF) Mercedes-Benz CLA

Change Car Particulate Filter (DPF)

Easy 0h30–6h00 ~50–600£
Estimated time 0h30–6h00
Estimated labour cost ~50–600£
Difficulty Easy
Vehicles
CLA 2013-2019 5
  • 180 CDI Diesel (607.951 (K9K))
  • 200 CDI Diesel (651.901)
  • 200 CDI, -4MATIC Diesel (651.930)
  • 220 CDI, -4MATIC Diesel (651.930)
  • 220 CDI, -4MATIC Diesel (651.930)
CLA 2019-2025 4
  • 180 CDI Diesel (608.915)
  • 180 D Diesel (654.920)
  • 200 D Diesel (654.920)
  • 220 D Diesel (654.920)
Remove/refit the diesel particulate filter 2h00–19h00
Renew the diesel particulate filter 2h00–19h00
Remove/refit the diesel particulate filter/catalytic converter assembly 2h00–7h00
Renew the diesel particulate filter/catalytic converter assembly 2h00–7h00
Prepare the catalytic converter heat shield for installation* 0h45
Check the catalytic converter 0h30
Remove/refit the catalytic converter 1h30–3h30
Renew the catalytic converter 1h30–3h30
Remove/refit the AdBlue tank control unit 0h30
Remove/refit the AdBlue tank 3h00
Drain/refill the AdBlue tank 0h45
Renew the AdBlue tank control unit 0h30
Renew the AdBlue tank 3h00

What is a Mercedes-Benz CLA particulate filter?

Diesel engines and direct-injection petrol engines produce soot particles. The particulate filter (DPF/GPF) traps these harmful particles as exhaust gases pass through its honeycomb structure. It is placed on the exhaust line after the catalytic converter.

How does the Mercedes-Benz CLA particulate filter work?

As soot accumulates, the filter periodically burns off (regenerates) the trapped particles. Active regeneration raises exhaust temperatures to 550–600°C, burning soot to ash. This occurs every 300–500 km during normal motorway driving. Vehicles driven only on short urban trips may not regenerate properly, leading to blockage.

When should you change the Mercedes-Benz CLA particulate filter?

The DPF is designed to last 150,000–250,000 km but depends on driving patterns. Signs of needed replacement: DPF warning light, engine in limp mode, excessive exhaust smoke, or diagnostic scan showing excessive back-pressure or failed regeneration cycles.

Can the Mercedes-Benz CLA particulate filter be cleaned instead of replaced?

Yes, professional DPF cleaning can restore a blocked filter at a fraction of replacement cost. However, if the filter substrate is cracked, melted, or structurally damaged, replacement is the only option. Never use a DPF removal/delete service — it is illegal and will fail the MOT/emissions test.

Is it difficult to change the Mercedes-Benz CLA particulate filter?

Difficulty level 2/5: technically straightforward but physically demanding due to the filter's location and weight. Key steps: raise the vehicle, disconnect pressure sensors, remove exhaust clamps/bolts, lower the old DPF, fit the new one with new gaskets, reconnect sensors, clear fault codes, perform a forced regeneration cycle.

2 models covered

Model Year Range Engines covered Fuel
CLA 2013-2019 2013-2019 180 CDI Diesel (607.951 (K9K)), 180, -LPG LPG,Petrol (270.910), 200 CDI Diesel (651.901), 200 CDI, -4MATIC Diesel (651.930), 200 Petrol (270.910), 220 4MATIC Petrol (270.920), 220 CDI, -4MATIC Diesel (651.930), 220 CDI, -4MATIC Diesel (651.930), 250, -4MATIC Petrol (270.920), 25… Diesel, LPG, Petrol
CLA 2019-2025 2019-2025 180 CDI Diesel (608.915), 180 D Diesel (654.920), 180 Petrol (282.914), 200 D Diesel (654.920), 200 Petrol (282.914), 220 D Diesel (654.920), 220, 4MATIC 48V (MHEV),Petrol (260.920), 250 e Electricity,Petrol (282.914), 250, 4MATIC 48V (MHEV),Petrol (260.920), AMG 35 Petrol (260.… 48V (MHEV), Diesel, Electricity, Petrol